ElektronIQ

Translations of this page:

VCO-POS

Function

The device is a RF source based on the Minicicuit's POS range of voltage controlled oscillators. The output is a fixed amplitude radio frequency signal with frequency tunability over the range specified by the POS VCO.

Performance

FIXME

Date

Project date: May 2011

Developer

Hrishikesh Kelkar, kelkar@iqo.uni-hannover.de

User

This VCO (qty:2) is currently being used in the Magnesium experiment.

Operating principle

The circuit is based on a Minicircuits POS VCO. A stabilized voltage is provided to the POS oscillator, which creates a RF output for EOMs or AOMs. A wide range of RF frequencies can be produced by simply choosing the POS oscillator of desired frequency.

Circuit diagram

Layout

Housing

FIXME

Test

Before you solder the POS VCO, check if the voltage at the pad of pin 1 is correct. Also check if the voltage of pad 8 can be tuned using the potentiometer. Once the VCO is soldered, tune the frequency via the poti and look for the bandwidth. It should be within the specified range (e.G. POS-100: 50 - 100 MHz)

Photos

Price estimate

What How many E-Preis (€) Preis (€) Note
PCB 1x 4 4 60 boards for 240 € from Basista
Housing 1x ??.?? ??.??
POS-x 1x 60 60
R,C 5x 0.02 0.10
Diode 2x 0.05 0.10
Voltage reference 1x 0.50 0.50
Sum 64.70 €

Meckerliste

Was für die nächste Version zu tun ist: (:no:: verworfen, :Ok:: in Arbeit, :ok:: im Schaltplan, aber noch nicht im Layout, :OK:: erledigt)

  1. :ok: Different voltage reference than 12 V, since you aren't able to tune the full range with only 12 V. Solution: Use 78L15 as reference.
  2. Add a better voltage reference like REF02 or similar which is way more stable than 7815 so you get less frequency drifts.